Serial Error    An internal communication error occurred. Re-boot the machine.
 JAM1    The plate is jammed. Cutter not completed cut.
 JAM2    The plate is jammed. Continual discharge.
 JAM3    The plate is jammed. Plate not discharged.
 I/F Error 1    A SCSI communication error occurred. Re-boot the machine.
 ME1    The Cutter does not return to its initial position. Turn on the Power
 Switch again.
 ME2    The Cutter in not located at its initial position. Turn on the Power
 Switch again.
 ME3 Nip Free    The Nip Roller is open. Close the Nip Roller clearance handle.
 ME4    An internal communication error occurred in the machine
 ME5    An internal communication error occurred. Re-boot the machine.
 ME6    The Laser does not light. It may be caused by low Laser.
 ME7    A problem occurred in the Polygon Mirror.
 ME8    A problem occurred in the Processor Heater.
 ME9    A problem occurred in the Heat Roller.
 ME10    A problem occurred when the Punch Unit was activated.
 Disk 01 Error    It may be impossible to use the Disk “01”.
 Disk 02 Error    It may be impossible to use the Disk “02”. 
 Disk Not Found    The Hard Disk drive cannot be found.
 Disk Crash    The Hard Disk drive mounted on this machine cannot be used.
 Please Format HD    The Hard Disk is not formatted.
 HD Partition Error    Format the Hard Disk.
 Punch Un-mounted    The Punch is not mounted.
 Close Front Door    The front door is open. Shut the door.
 Width Not Enough    The width of the plate is insufficient for the exposure width. Replace
 the plate with one as wide as the exposure.
 Image Error    An internal data transmission error occurred. Re-boot machine.
 Plate Set Error    The plate has not been set correctly. Re-set the plate.
 Plate End    The plate ran out. Load new plate.
 Pick Up Plate    Open the front door end remove a strip type plate through the plate
 removal port.
 Waste Tank Check    The waste chemical tank is full.
 Empty EAC    The EAC chemical ran out. Replenish it.
 Empty EST    The EST chemical ran out. Replenish it.
 Tray Check    The overflow try has not been set. Set the tray.