Machine Error Codes‎ > ‎ECRM Series‎ > ‎

Stingray 46 & 63

 
  
 Error Message:                        Possible Cause:
 System Error #1
 ( Drive Motor Error)
   The Motor connector is not properly connected.
 The Motor has failed.
 Controller failure.
 System Error #2
 (No Spinner Index Error)
   Spinner Motor may not be functioning.
 Controller failure.
 System Error #3
 (No active video)
   J1 shunt is not installed on AP27354.
 The AP140004 Board is defective.
 System Error #4
 (Cutter Error)
   The Cutter may have stopped.
 May have a faulty Cutter Parked Sensor.
 Set screw on the Cutter Motor pulley may have loosened.
 System Error #5
 (DC Lazy Loop error)
   Lazy Loop Motor failed.
 Controller failure
 System Error #6
 (Head Punch Error)
   Loose cable.
 Head Punch Motor failed.
 Controller failure.
 Parked Sensor faulty or misadjusted.
 System Error #7
 (Tail Punch error)
   Loose cable.
 Tail Punch Motor failed.
 Controller failure.
 Parked Sensor faulty or misadjusted.
 System Error #8
 (Pinch error)
   Loose cabling.
 Bad Pinch Motor.
 Incorrect Sensor adjustment.
 Defective sensor.
 System Error #9
 (Spinner speed test
  failure)
   Loose cable.
 Insufficient voltage / current
 Spinner Controller board fails to maintain speed.
 Bad Spinner

Transport 
Error 
Message:                                   Possible Cause:
 FLAP 1 CURRENT
 FLAP 2 CURRENT
 LIFT 1 CURRENT
 ROLLER CURRENT
   - The transport has detected a problem operating a flap, lift, or roller motor.
 - The flap or lift may be obstructed.
 - The flap, lift, or roller motor wire may be shorted.
 - Call Service if problem persists.
 FLAP 1 TIMEOUT
 FLAP 2 TIMEOUT
 LIFT 1 TIMEOUT
   - The transport flap or lift has not arrived at its destination on time.
 - The flap or lift may be obstructed.
 - The flap or lift wire may be loose.
 - Call Service if problem persists.
 SENSOR TIMEOUT    - The media did not reach the sensor on time.
 - Sensor 3 does not detect leading edge of media within 30 seconds when
   MOVING MEDIA.
 - Sensor 4 does not detect the trailing edge of media when BUFFER 2 LOADING.
 - Sensor 4 does not detect the trailing edge of media when LOADING CASSETTE.
 - The sensor leads may be loose.
 - The sensor may be out of alignment.
 - The sensor may be bad.
 KEYPAD ABORT    - You have initiated abort by pressing the STOP key while the roller was moving media.
 EEPROM CRC    - The Transport has failed to remember setup values stored in EEPROM.
 - The Transport may have lost power while you were storing values.
 - Press PREV left arrow on the Transport Controller Board to clear this error. Default
   values will be stored to EEPROM.
 VOLTAGE HIGH
 VOLTAGE LOW
  - Power-On Self-Test error.
 - Power input(s) to transport PCB is/are missing or out of tolerance.
 - The connector may be loose or missing.
 SENSOR STATE  - Power-On Self-Test error.
 - The transport program cannot resolve the current state of transport.
 - The sensor leads may be loose.
 - The sensor may be out of alignment.
 - The sensor may be bad.