Machine Error Codes‎ > ‎ECRM Series‎ > ‎

Marlin 46 & 63

         
 Problem:                               Possible Cause:
 System Error #1
 ( Drive Motor Error)
   The Motor connector is not properly connected.
 The Motor has failed.
 Controller failure.
 System Error #2
 (INDEX Error)
   Spinner Motor may not be functioning.
 Controller failure.
 System Error #3
 (No active video)
   J1 shunt is not installed on AP27354.
 The AP140004 Board is defective.
 System Error #4
 (Fatal Cutter Error)
   The Cutter may have stopped.
 May have a faulty Cutter Parked Sensor.
 Set screw on the Cutter Motor pulley may have loosened.
 System Error #5
 (Lazy Loop failed)
   Lazy Loop Motor failed.
 Controller failure
 System Error #6
 (Head Punch Error)
   Loose cable.
 Head Punch Motor failed.
 Controller failure.
 Parked Sensor faulty or misadjusted.
 System Error #7
 (Tail Punch error)
   Loose cable.
 Tail Punch Motor failed.
 Controller failure.
 Parked Sensor faulty or misadjusted.
 System Error #8
 (Pinch Not Parked error)
   Loose cabling.
 Bad Pinch Motor.
 Incorrect Sensor adjustment.
 Defective sensor.
 System Error #9
 (Spinner confidence 
  test failure)
   Loose cable.
 Insufficient voltage / current
 Spinner Controller board fails to maintain speed.
 Bad Spinner